141
18.1.5 Removing the Control Board (Auto OFF/ON Button)
1 Perform “18.1.1 Removing the Front Panel”.
2 Perform “18.1.3 Removing the Front Grille (Right) and Front Grille (Left)”.
* Note on disassembly: When removing only the control board (Auto OFF/ON button), remove the front grille
(left) only.
3 Remove lead wire casing. (There are 3 tabs at the casing).
4 Disconnect connector CN-SW (white)……….Control board (Auto OFF/ON button).
5 Disengage the tab (2 locations) on both sides of the control board. Then, remove the control board from
casing.
CN-SW (white)
To Next Page
Loading...
