Panasonic CS-VZ12SKE - Page 145

145
18.1.8 Removing the Indicator, Receiver & Human Sensor Control Board to below side
1 Perform “18.1.1 Removing the Front Panel”.
2 Perform “18.1.2 Removing the Air Filters”.
3 Perform “18.1.3 Removing the Front Grille (Right) and Front Grille (Left)”.
4 Disengage the tabs (2 locations) located at indicator, receiver and human sensor control board. Then, Pull
down the indicator, receiver and human sensor control board.
Tab
Indicator, Receiver and Human Sensor control board
Tab
18.1.9 Removing the Indicator, Receiver & Human Sensor Control Board from unit
1 Perform “18.1.1 Removing the Front Panel”.
2 Perform “18.1.2 Removing the Air Filters”.
3 Perform “18.1.3 Removing the Front Grille (Right) and Front Grille (Left)”.
4 Perform “18.1.6 Removing the Indicator, Receiver & Human Sensor Control Board”.
* Note on disassembly: When removing the Indicator, Receiver & Human Sensor Control Board from unit,
disconnect connector CN-DISP (white) only.
5 Perform “18.1.8 Removing the Indicator, Receiver & Human Sensor Control Board to below side”.
6 Push the hook (2 hook) to the front to disengage it.
Hook