Remote Control
Transmitter
Powerful operation
Note: The illustrations in this manual are for explanation purposes only and may differ from the
actual unit. It is subjected to change without notice for future improvement.
Air inlet (rear)
Air outlet
Air inlet (side)
Remote Control Preparation
■ About
• Timer operation will be based on
current time set.
• The batteries can be used for
approximately 1 year.
• The batteries must be
recycled or disposed of
properly.
• Make sure it is not obstructed.
• Maximum distances : 10m.
• Certain fluorescent lights may
interfere with signal transmission.
Consult your dealer.
Remote Control Signal
• To operate the unit if the
remote control is misplaced or
malfunctioning.
Action
Operation
mode
Press once
Automatic
Operation
Press until “beep”
sound
Cooling
Operation
• To OFF, press again the Auto OFF/
ON button.
• To switch the remote control signal
receiving sound off or on.
1. Press until “beep” sound and
release.
2. Press again until “beep-beep”
sound and release.
3. Press to switch the sound off or
on.
(Long “beep”- OFF; short “beep”
- ON)
Auto OFF/ON Button
5. Press again to confi rm
Outdoor Unit
Troubleshooting
● Operation delayed for few minutes after restart.
➤ This is a normal self protection control.
● Sound like water fl owing during operation.
➤ Caused by refrigerant fl ow inside.
● Mist emerges from indoor unit.
➤ Condensation effect due to cooling process.
● Noisy during operations.
➤ Installation work could be slanted or front panel didn’t close properly.
● Remote control/display does not work.
➤ Check whether batteries are correctly inserted or need replacement.
● The unit cannot operate.
➤ Check either circuit breaker is tripped, power plug is inserted correctly or
timer is used correctly.
● Outdoor unit emits water/steam.
➤ Condensation or evaporation happens at piping surface.
Ionizer
Do not touch
during operation
To Next Page
Loading...
Need help?
General
