83
Figure 3 Figure 4
16.1.3 To remove discharge grille
Figure 5
16.1.4 To remove control board
Figure 6
CN-MSENS
CN-STM3
CN-STM4
CN-STM2
CN-TH
CN-FM
AC303
CN-STM1
10. Detach 8 connectors as labeled from the electronic controller.
Then pull out electronic controller gently.
9. Pull out the
electronic
controller halfway.
8. Remove screw to
remove terminal
board complete.
7. Detach the
connectors
CN2 (Black),
GND (Green),
and CN1 (White)
then remove the
high voltage
generator.
6. Remove the
indicator complete
then detach the
connectors CN-DISP
and CN-RCV.
5. Detach the earth wire screw, terminal wire (Brown), terminal wire (Black),
terminal wire (Red) and earth wire screw (Green).
12. Pull out to remove the drain
hose from the discharge grille.
11. Detach the bottom plate then remove
2 screws of the discharge grille.
13. Then pull the discharge grille downward gently to dismantle it.
14. Remove the 4 screws holding
the control board then pull ou
the control board.
To Next Page
Loading...
