82
WARNING
16. Disassembly and Assembly Instructions
High Voltage is generated in the electrical parts area by the capacitor. Ensure that the capacitor has discharged sufficiently before proceeding with
repair work. Failure to heed this caution may result in electric shocks.
16.1 Indoor Electronic Controllers, Cross Flow Fan and Indoor Fan Motor
Removal Procedures
16.1.1 To remove front grille
Figure 1
16.1.2 To remove electronic controller
Figure 2
1. Remove 2 covers and 2 screws at the bottom
of front grille.
2. Lift to open the horizontal vane
gently.
3. Hold both sides of the front grille and
remove it by pulling up and toward
yourself gently.
3 Hooks (Top, left & right hand side)
4. Remove the control board cover
by releasing the 3 hooks.
To Next Page
Loading...
