32
To Learn More...
Operation mode
AUTO : The POWER indicator blinks at the initial stage.
The unit will select an operation mode every 10 minutes depending on the setting
and room temperature.
COOL : Provides efficient comfort cooling to suit your needs.
DRY : Operates at low fan speed for a gentle cooling operation.
Energy saving temperature setting
You may save energy when operating the unit within the recommended temperature range.
COOL : 26.0 °C ~ 28.0 °C / 79 °F ~ 82 °F.
Air flow direction
In COOL/DRY mode:
The horizontal fl ap is fi xed at middle position setting.
Once the temperature is achieved, the horizontal fl ap swings up/down automatically.
In COOL/DRY mode:
The horizontal fl ap swings up/down automatically.
Auto restart control
When power is resumed after a power failure, the operation will restart automatically with the
last operation mode and airflow direction.
• This control is not applicable when TIMER is set.
nanoe™X filter deactivation
Depending on the unit’s accumulated operation time, the nanoe™X may be activated only
once a day after the unit is turned off standby mode. During the nanoe™X filter deactivation
operation, the flap will open slightly with low fan speed operation for 2.5 hours if the unit was
in COOL/DRY mode, and 2 hours if the unit was in nanoe™ TECHNOLOGY, before the unit
is turned off. This is to remove viruses/bacteria from the surroundings.
The filter deactivation operation is complete when the fan stops and the flap closes. Do not
turn off the power supply during this operation. After a power failure, this operation will not
resume.
Operating conditions
Use this air conditioner in the temperature range indicated in the table.
Temperature °C (°F)
Indoor Outdoor
DBT WBT DBT WBT
COOL
Max. 32 (89.6) 23 (73.4) 46 (114.8) 26 (78.8)
Min. 16 (60.8) 11 (51.8) 16 (60.8) 11 (51.8)
DBT: Dry bulb temperature, WBT: Wet bulb temperature
ACXF55-29802_FA0121-2.indb 32ACXF55-29802_FA0121-2.indb 32 1/13/2021 8:23:38 PM1/13/2021 8:23:38 PM
To Next Page
Loading...
