Panasonic CT-20R6E - Service Adjustments: Picture and Color; Sub-Data, Cut-Off, and Picture Options

- 20 -
IMPORTANT
Registers marked as FIXED in the following tables, are factory preset,
service personnel should not change the default value.
Press the Power Button on the Remote Control to select the Service Adjustment.
For Adjustments:
Sub-Data Adjustment Adj. Range
Default
Level
B0 SUB-COLOR 0 ~ 127 33
B1 SUB-TINT 0 ~ 127 36
B2 SUB-BRIGHTNESS 0 ~ 255 127
B3 SUB-CONTRAST 0 ~ 127 20
B4 R-OFF SET
FIXED 0
B5 Y NOISE REDUCTION
FIXED 0
B6 Y NR LIMIT FIXED 0
Cut-Off Adjustment Adj. Range
Default
Level
C0 CUT-OFF R
0 ~ 255
1 ~ 255
0
255
C1 CUT-OFF G
0 ~ 255
1 ~ 255
0
255
C2 CUT-OFF B
0 ~ 255
1 ~ 255
0
255
C3 DRIVE R 0 ~ 127 80
C4 DRIVE B 0 ~ 127 80
C5 DRIVE G 0 ~ 127 80
C6 VERTICAL SIZE 0 ~ 255 127
C7 NOT USED N/A N/A
C8 NOT USED N/A N/A
C9 HORIZONTAL CENTER 0 ~ 31 16
Ca BEAM LIMIT 0 ~ 1 1
Cb HHS 0 ~ 7 0
Cc OSD-SHIFT
FIXED 88
Cd ACL-REF
FIXED 74
1.Press Channel Up/Down on the
Remote Control to select one of
the available Service Adjustments
(a in Fig. 20).
Note: Write Down the original
value set (b in
Fig. 20
) for each
address before modifying
anything. It is easy to
erroneously adjust the wrong
item.
2.Press Volume Up/Down on the
Remote Control to adjust the
level of the selected Service
Adjustment (b in Fig. 20).
CH
CH
CH
PW
To Item C0f
CH
CH
CH