■ Operation Details
Auto, Heat, Cool, Dr y
• The unit will automatically select
the operation mode according
to the setting, outdoor and room
temperature. During operation mode
selection, power indicator blinks. For
every 3 hours, the operation mode is
reselected.
• Enables you to enjoy the cooling
effect at your preferred setting
temperature.
• Enables you to set the desired
temperature at low fan speed which
provides you with the dehumidifying
surroundings.
Troubleshooting
2
Select the
desired
operation.
3
Set the
temperature.
(16ºC ~ 30ºC)
AUTO - Automatic Operation
COOL - Cooling Operation
DRY - Soft Dry Operation
Start the
operation.
1
HOW TO OPERATE
● For DK-series indoor unit, supersonic air purifying device
(super alleru-buster) operates automatically while the air
conditioner is switched on.
● Powerful and Quiet operations could be activated in all
operation modes.
● Press
button again to stop the operation.
● Power indicator blinks.
➤ The operating mode is different from other indoor unit.
● Operation delayed for few minutes after restart.
➤ This is a normal self protection control.
● Sounds like water flowing during operation.
➤ Caused by refrigerant flow inside.
● Cracking sound can be heard during operations.
➤ Panel expanding/contracting due to change in temperature.
● Occasionally knocking sound is heard.
➤ Switching over of refrigerant gas in the system during defrosting and at
the end of operations.
● Heat is obtained from outdoor air to warm up the room. Use additional heater when outdoor ambient temperature is low.
Hint
• Enables you to enjoy the warming
effect at your preferred setting
temperature.
• For cold air prevention, air might
not blow out immediately and power
indicator blinks when operation
starts.
• Also operates in defrost mode
(maximum 12 minutes) where by the
power indicator blinks. The melted
frost is drained at outdoor unit and
indoor fan is stopped.
HEAT - Heating Operation
For DT & DD-series
indoor unit
For DK-series
indoor unit
To Next Page
