Panasonic CU-A120KE - Page 30

CS-A70KE
Installation Information
Indoor / Outdoor unit installation diagram
Length of power supply cord
about 1.4m about 1.8m
(cs fee
Right
rear
Piping direction.
(Front side)
aor SY)
Le =
Right bottom rear
Attention not to bend up drain hose
eee ||
Left bottom
(Left and right are identical)
Insulation of piping connection
e Carry out insallation
after checking for gas
leaks.
After securing with
three of the vinyl
tape [8], wrap with
vinyl tape [9].
TN
Ho
AO
mi
A
it
ET
LT
UT
W/
¢ This illustration is for explanation purposes only.
The indoor unit will actually face a different way.
“Ait purifying filter [5]
Vinyl tape
Installation parts you must
purchase (X)
installation plate [1]
Sleeve (><)
Bushing-Sleeve (><)
Putty, (Gum Type Sealer) (X)
Bend the pipe as closely on the
wall as possible, but be careful
that it doesn’t break.
Vint! tape (Wide) (X)
e Apply after carring out a
drainage test.
To carry out the drainage
Vinyl tape test, remove into the heat
[a d exchanger. To carry out the
drainage test, remove into
the heat exchanger.
Saddle (X)
Connecting cable
(5-CORE WIRE/1.5mm?)
Locally approved cable.
Additional drain hose (X)
1/4" Liquid side piping (><)
Gas side piping (<)
3/8” (A70KE, AQ9OKE)
1/2" (A120KE)
Vinyl tape (X)
(Narrow)
—29—