COMFORT
,
• Can be activated in all modes and can be cancelled by
pressing the respective button again.
• Cannot be selected at the same time.
• Cannot be activated during “MILD DRY COOLING”
operation is activated.
6
TO ENJOY CLEAN & FRESH AIR
PATROL
• PATROL operation detects air
quality; e-ion operation activates
when air quality is at dirty level.
• When e-ion operation activates, it
generates negative ions to produce fresh
air effect and attract dust which will then
be captured at the positively charged e-ion
fi lters.
• PATROL operation can be activated even when the
unit is turned off. When e-ion operation activates in this
condition, fan speed and air swing can not be adjusted.
• PATROL starts automatically with the unit switched on
with
OFF/ON
.
7
TO IMPROVE HUMIDITY AND MOISTURE LEVEL
• This operation reduces air dryness and provides you with
a comfortable living environment during COOL mode only.
• When vertical airfl ow direction is set to AUTO, it stops at
lower position to avoid cold air contact. However, you can
adjust the louver direction manually.
8
TO SWITCH BETWEEN
POWERFUL & QUIET
POWERFUL/QUIET
POWERFUL/
QUIET
QUIETPOWERFUL NORMAL
UIET
TO ENJOY QUIET OPERATION
• This operation reduces airfl ow noises.
• When this operation is activated, the
indicator brightness will be dimmed.
9
10
TO MONITOR HUMAN PRESENCE &
ACTIVITY FOR ENERGY SAVING &
COMFORT
To optimize energy
saving
AUTO
COMFORT
To maximize comfort
AUTO COMFORT
• When either operation is activated, the unit will start
to initialize for approximately 1 minute. Human activity
indicator is blinking in sequence.
• After initialization, the human activity sensor will start
to detect the level of heat source & movement, the unit
adjusts the temperature and airfl ow to keep you comfort
consistently.
Set Fan Speed
-2°C
-2°C
Heat Mode
Set Temperature
+0.3°C
Heat Source & Movement
Normal
High
Low None
Set Fan Speed
≤ Medium
Fan
+1 tap*
+2°C
-1°C
+1°C
+1 tap
Cool/Dry Mode
Set Temperature
* For first 15 minutes or until set temperature is reached.
• Human activity sensor will also scan for area of heat
source and movement in a room.
Human activity indicator Heat source & movement
At left area of the room
At right area of the room
At centre area or multiple areas
of the room.
• The unit will determine the heat source & movement
hotspot, and automatically adjust horizontal airfl ow
direction louver either fi x at predetermined position or
swing left/right.
Detection area (top view)
7m
120º
• When manual AIR SWING is selected, the ECONAVI
and AUTO COMFORT operation will be cancel.
• Sensor may not detect moving objects further than 7m
away or beyond detection angle.
• Sensor sensitivity is infl uenced by indoor unit location,
movement speed, temperature range, etc.
• The sensor may mistakenly detects pets, sunlight, certain
lighting, fl uttering curtains and light refl ection as human
being.
F568133-YS0311-0_1EN.indd 7F568133-YS0311-0_1EN.indd 7 07-Jun-11 9:59:07 AM07-Jun-11 9:59:07 AM
To Next Page
Loading...