Why does my Panasonic CU-Z50VKR Air Conditioner outdoor unit emit water or steam?
The emission of water or steam from the outdoor unit is due to condensation or evaporation occurring on the pipes.
Why is my Panasonic Air Conditioner remote control not working?
If your Panasonic Air Conditioner remote control isn't working, ensure the batteries are inserted correctly. If the display is dim or the transmission signal is weak, try replacing the batteries with new ones.
Why is the TIMER indicator always on on my Panasonic Air Conditioner?
The timer setting repeats daily once set.
Why is my Panasonic CU-Z50VKR Air Conditioner making a louder noise at the outdoor unit during early operation of i AUTO-X?
The compressor and fan rotate at a higher speed to boost cooling performance during initial operation.
Why does the POWER indicator blink on my Panasonic CU-Z50VKR before it's switched on?
The blinking POWER indicator is a preliminary step in preparation for operation when the ON timer has been set. When the ON Timer is set, the unit may start earlier (up to 35 minutes) before the actual set time in order to achieve the desired temperature on time.
Why does airflow continue after I stop my Panasonic CU-Z50VKR?
The airflow continues even after operation has stopped because the unit is extracting remaining heat from the indoor unit, which can take up to 30 seconds.
Why is my Panasonic CU-Z50VKR making a cracking sound during operation?
The cracking sound during operation is caused by changes in temperature, leading to the expansion or contraction of the unit.
Why does my Panasonic CU-Z50VKR Air Conditioner make a water flowing sound during operation?
The water flowing sound you hear during operation is due to the refrigerant flow inside the unit.
Why is there a delay after restarting my Panasonic CU-Z50VKR Air Conditioner?
The delay is a protection mechanism for the unit’s compressor.
Why does mist emerge from my Panasonic Air Conditioner indoor unit?
The mist emerging from the indoor unit is a condensation effect due to the cooling process.
Explanation of warning, caution, and prohibition symbols for safe use.
Safety for indoor/outdoor units, remote control, and power supply.
Specific safety measures for unit installation and operation.
Precautions for power cords, connections, and the nanoe-G generator.
Safety guidelines when handling R32 refrigerant and installation.
Requirements for trained and certified personnel for servicing.
Safety measures and precautions during servicing work.
Checks for refrigerant presence, fire extinguishers, and ignition sources.
Procedure for safely removing and evacuating refrigerant.
Steps for charging refrigerant and decommissioning the unit.
Guidelines for safely recovering refrigerant into cylinders.
How to retrieve diagnostic error codes using the remote control.
List of error codes and corresponding abnormality/protection controls.
General| Cooling Capacity | 5.0 kW |
|---|---|
| Heating Capacity | 5.8 kW |
| Power Supply | 220-240V, 50Hz |
| Energy Efficiency Ratio (Cooling) | 3.21 |
| Energy Efficiency Ratio (Heating) | 3.61 |
| Noise Level (Outdoor) | 53 dB(A) |
| Refrigerant | R32 |
| Type | Split System |
To Next Page
