Panasonic CW-XC243HU - Tool Requirements and Chassis Preparation

,Suggested ToolRequirements
I
PREPARATION OF CHASSIS
1. Remove the screws which fasten the cabinet at
both sides and at the back.
SCREWDRIVER(+, -), RULER, KNIFE, HAMMER, PENCIL, LEVEL
Shippingscrews
2. Slide the unit out from the cabinet by gripping the
base pan handle and pulling forward while
bracing the cabinet,
3. Cut the window sash seal to the proper length,
Peel off the backing and attach the Foam-PE to the
underside of the window sash,
Fig. 1
4. Remove the backing from Foam-PE with 3 holes
and attach it to the bottom of the Top retainer bar.
5. A_ach the Top retainer bar on the top of the
cabinet with 3 screws (Type A),
6, insert the Frame guides into the bottom of the
cabinet,
7. insert the Frame Curtain into the Top retainer bar
and Frame guides.
Fo_m-PE
Topretorter bar
8. Fasten the cu_ains to the unit with 10 screws
(Type A) at both sides,
Top retainerbar
rew
(T_e A)
--Frame guide
Screw(TypeA)