13
Setting connection network
1.
Tap “Next” after con rming the
POWER LED of the WLAN Adaptor
is ON.
2. Select the option that matches the
status of LINK LED.
<Note>
● When the “SETUP” button on the WLAN
Adaptor can not be operated or when you
can not check the LED
1. Tap “Next”.
2. Select “LED is OFF”.
3. Select “Connect with AP mode”.
3. Select the preferred router support
connectivity mode.
Connection network using WPS
mode (method 1)
1.
Press the “WPS” button on the router
to establish connection.
2. Tap “Next” after the router is ready for
connection.
1_WLAN Adaptor_CZ-CAPWFC1_En.indd 13 2018/12/27 18:13:52
To Next Page
Loading...
