Panasonic CZ-RD52CU

English
3
Press the remote control’s button
1
TO TURN ON OR OFF THE UNIT
• Please be aware of the OFF indication on the
remote control display to prevent the unit from
starting/stopping improperly.
2
TO SET TEMPERATURE
• Selection range: 60°F ~ 86°F.
3
TO SELECT OPERATION MODE
AUTO mode - For your convenience
• Unit selects operation mode during startup
according to temperature setting and room
temperature.
HEAT mode - To enjoy warm air
• Unit takes a while to warm up. The power
indicator blinks during this operation.
COOL mode - To enjoy cool air
• Use curtains to screen off sunlight and outdoor
heat to reduce power consumption during cool
mode.
DRY mode - To dehumidify the environment
• Unit operates at low fan speed to give a gentle
cooling operation.
4
TO SELECT FAN SPEED
(Remote control display)
FAN SPEED
• For AUTO, the indoor fan speed is
automatically adjusted according to the
operation mode.
5
TO ADJUST VERTICAL AIRFLOW
DIRECTION
(Remote control display)
AIR SWING
• Keeps the room ventilated.
• In COOL/DRY mode, if AUTO is set, the louver
swing up/down automatically.
• In HEAT mode, if AUTO is set, the horizontal
louver fi xed at predetermined position.
• For Hide-Away models, AIR SWING buttons
are not in use. Airfl ow direction can not be
adjusted.
6
Press and hold for approximately 10
seconds to show temperature setting in °C
or °F.
7
Press and hold for 5 seconds to dim or
restore the unit’s indicator brightness.
8
Press to restore the remote control’s
default setting.
9
RETRIEVE ERROR CODE
• During operation, the unit stops and both
a
and
b
is OFF indicates abnormality occurs.
1. Ensure
a
is OFF, press for 5 seconds.
2. Press or . If error code and abnormality
can be identifi ed,
a
will be ON continuously,
then write down the error code.
3. Press for 5 seconds to quit checking.
4. Turn the unit off and reveal the error code to
authorized dealer.
Note: Press
for 10 seconds to enter AC reset
switch (Not used in normal operation).
10
AIR FILTER MAINTENANCE
Cleaning is needed when “FILTER CHECK”
indicator is ON.
• lt is recommended to clean the air fi lter every 6
weeks.
• After the air fi lter is cleaned, press to
reset.
• Do not operate without an air fi lter.
• Wash/rinse the fi lters gently with water to avoid
damage to the fi lter surface.
• Do not dry the part with a hair dryer or a stove.
• Replace any damaged fi lters.
11
TO SWITCH BETWEEN POWERFUL &
QUIET
POWERFUL/
QUIET
QUIETPOWERFUL NORMAL
POWERFUL: To reach temperature quickly
• This operation stops automatically after 20
minutes.
QUIET: To enjoy quiet operation
• This operation reduces airfl ow noise.