Panasonic CZ-RTC2

EN-7
EN
• Changing the Program Timer
To set the weekly program, follow the steps below.
1. Select the program you want to set in the program
confi rmation mode, and press
. This enters the
setting mode of the program currently displayed.
* In the program setting mode,
, “hour”, “minute”
and “item” fl ash on the display.
2. Set the “hour”. (program step 1)
Press
/ to set the “hour”.
Confi rm the “hour” and press
. This enters the program changing
mode
(setting of the “minute”).
3. Set the “minute”. (program step 2)
Press
/ to set the “minute”.
Confi rm the “minute” and press
.The unit enters (the program
pattern selection mode).
1,2,3,4 4
2,3,4
Program step1
Program step2
SET
SET
SET
SET
CANCEL,DEL
normal remote controller
program check
PROGRAM CANCEL
CANCEL,DEL
CANCEL
PROGRAM
SET,CANCEL,DEL
SET,CANCEL
Program
Changing hour digits
Changing minute digits
Changing patterns
Selecting copy source
Selecting copy destination
CZ-RTC2Main.indbEN-7CZ-RTC2Main.indbEN-7 2011/06/1615:26:142011/06/1615:26:14