Panasonic CZ-RTC2

1. Setting day of the week and current time of day: Push and hold the
“SET” KEY and the hours will start blinking. While hours or
minutes are blinking, you can also now set the day of the week. Press
the “UP” or “DOWN” DAY KEY until desired day is highlighted.
Set the correct hour of the day using the “UP” or “DOWN”
ARROW KEY followed by the “SET” KEY. The minutes will now
start blinking. Set the correct minutes using the TIMER “UP” or
“DOWN” ARROW KEY followed by the “SET” KEY.
The time Note: on the remote is set in “military time”, this range
will be from 0:00 a.m. (representing midnight) - 23:59 hours p.m.
2. Setting a timed function:
Press the “PROGRAM” KEY “CH 1”
will then appear in LCD display. Set the day of the week you want to
schedule an On/Off timed function, by pressing the “UP” or
“DOWN” DAY KEY, until the arrow emblem appears above the day
to be programmed.
.
 There can be up to 6 timed functions per day. Press the
“UP” or “DOWN” TIMER KEY and set the function from
1 to 6. Example: If only one timed function is needed for a
particular day you would select timer No. 1 then you would
see the following display.
For this
example we are showing timer No. 2. Next press the “SET”
KEY then
will appear on the LCD
display.