Panasonic CZ-RTC6

11
(EN)
ECONAVI function
Note
z ECONAVI can be set using the separately sold ECONAVI panel or by connecting
the holder on the wall.
z Even when target temperature is changed through the ECONAVI function, the set
temperature shown in the remote controller does not change.
z Even when Cooling/Heating is changed to Fan through the ECONAVI function, the
operation mode shown in the remote controller will still be Cooling/Heating.
z It is possible to choose from the following options for the operation to be
performed after a lapse of 3 hours* since the room has been empty.
• Operates in the Fan mode only.
• Stops and resumes operations after human movements are detected.
•
Stops and will not resume operations even after human movements are detected.
• Continues to operate in the current mode.
If you need to do so, please contact the dealer.
* This depends on the type of indoor unit.
z Turn the ECONAVI function OFF if:
- You want to maintain the room temperature at a set temperature.
- You want to keep air conditioner running while nobody is in a room.
- The sensor fails.
- Only infants, babies, or people only with disabilities are in the room.
z When operating more than one indoor unit, the energy-saving effect may be
reduced depending on the room condition.