Panasonic CZ-RTC6

23
(EN)
Troubleshooting
T he remote controller
screen displays
“
” “ ” .
(alternately)
z Faulty sensor or incorrect installation.
→Turn OFF the ECONAVI function with the remote
controller (P.12) and contact the retailer
or point of purchase with the Model No. and
problem.
The remote
controller screen
does not display the
.
z The indoor unit has stopped. Turn on the
indoor unit.
z The unit is in Fan mode (
). The ECONAVI
function does not operate in Fan mode.
z The ECONAVI function is set to OFF. Turn
the ECONAVI function ON with the remote
controller. (P.12)
z The indoor unit may not support the
ECONAVI function. If you turn the ECONAVI
function ON with the remote control but
there is no change, the indoor unit does not
support the ECONAVI function.
Please contact the dealer.
The remote controller
screen displays
“ ” “ ”.
(alternately)
z nanoe™ X is considered abnormal.
→Turn OFF the nanoe™ X function with the remote
controller (P.14) and contact the retailer
or point of purchase with the Model No. and
problem.
• If you need to contact for servicing, check the back cover of the operating instructions for indoor
units or outdoor units.