Panasonic CZ-TAW1 - Adaptor Installation

9
English
Adaptor Installation
1 

connector on the printed circuit board�
 Shut off the power supply when installing this adaptor.
 Attach the EMC core to the cable.
 Pull the cable out of the indoor unit so there is no pinching.
 If an optional PCB has been installed in the indoor unit, connect to the
CN‑CNT connector of the optional PCB.

With optional PCBWithout optional PCB
CN‑CNT
connector
CN‑CNT
connector
EMC core
EMC core
2 
the adaptor and remove the cover� Connect the other

inside the adaptor�
Slot
Connector