Getting started
VQT2J69
11
1 Standby/on switch (Í/I) (> 16, 18)
Press to switch the unit from on to standby mode or vice
versa. In standby mode, the unit is still consuming a
small amount of power.
2 Disc tray (> 16)
3 Connection for digital video (DV) camcorder (> 60)
4 Blue LED
≥It is possible to set the LED to turn on/off. (> 80)
5 Display (> below)
6 Recording indicator
7 Remote control signal sensor (> above)
8 Connection for VCR, Panasonic’s video camera, etc.
(> 60)
9 Open/close disc tray (> 16)
: SD card slot (> 16)
; USB port (> 16)
< Channel select
= Start recording/One Touch Recording (> 26)
> Stop
? Start play
Rear panel terminals (> 12, 13, 14, 15)
1 SD card slot indicator
2 Copying indicator
3 Disc indicator
4 Drive (HDD, BD or SD) indicator
5 Remote control signal indicator
6 Main display section indicator
Current time/playback counter, various messages
7 Playback indicator
8 USB port indicator
9 Timer recording indicator
This indicator lights up when the timer recording standby
is activated.
Main unit
DV IN
AV2 IN
30
30
20
20
Pull to flip down the front
panel.
Distance: Within approx. 7 m in front of the unit
∫ Remote Control signal sensor
The unit’s display
PLAY
COPY
SD USB
HDDSD
BD
DMRBW880&780GL-VQT2J69_eng.book 11 ページ ２０１０年２月１９日 金曜日 午後３時３０分
To Next Page
Loading...
