POWER
Lamp _,
1
2
Connect and plug in the Cable as
shown.
• POWER Lamp will light.
• Disconnect DC Cable if it is
connected to AC Adaptor,
50 80 100%
Attach the battery as shown to
charge.
• Charge lamps on the AC Adaptor will
flash and then turn solid green to
indicate current charge level. When all
3 lamps are constantly on, the battery
is fully charged. (approx. 1 hour)
Expect approx. 1 hour 15 minutes of
operation when fully charged
(EVF usage).
Remove the Battery.
Slide the Battery out and then lift up.
• The three Charge Lamps "50%", "80%" and "100%" flash and then remain lit one after
another to indicate how much the Battery has been charged. When all three lamps are
lit, charging is finished.
• The Charge Lamps give a good approximate indication of the charging condition under
normar ambient temperature. However, when charging at high or low temperature, the
charge lamps may differ considerably from the actual charging condition.
• When you charge two batteries, charging starts from Battery 1. At this time, the Charg-
ing Lamps for Battery 2 show the remaining charge of Battery 2. (If the remaining charge
is less than 50%, no Charge Lamp is lit.)
Battery Charging Confirmation Marker
Use this marker as a reminder to yourself
when the battery is fully charged or in need
of a charge. This marker performs no
function and is for your reference only.
• The Battery is no longer serviceable ifthe
operation time is very short, even after a
sufficient charge.
10 For assistance, call 1-800-211-PANA(7262)
To Next Page
Loading...
