To brighten the natural colors in a scene.
Slide Light into the Built-in Light
Mount.
Be sure it locks into place.
Press LIGHT Button ON.
Press LIGHT Button again to OFF.
LIGHT RELEASE
Button
LIGHT Button
To remove the Light:
Press LIGHT RELEASE Button and slide
the Light out of the mount.
Caution:
This light becomes hot during operation.
Make sure nothing covers the Light during
operation.
Note:
• Using the light will reduce battery operating time.
• If using the enhancement Light for an extended period of time, be sure to provide
ventilation when using it in a hot environment.
• Be sure LIGHT Button is set to OFF when not in use.
• Do not attempt to lift or carry the Palmcorder by holding the Enhancement Light.
• If light bulb needs to be replaced, take Light to your nearest service center.
24 For assistance, call 1-800-211-PANA(7262)
To Next Page
Loading...
