POWER Lamp
CHARG_
Connect and plug in the Power Cord
as showr_.
: POWER Lamp will tight.
Remove the DC Cab_e, if attached,
from the adaptor.
Attach the Battery as shownto
charge.
• CHARGE Lamp lights up. It goes out
when charging is complete {approx, 1
hour), Expect approx. I hour 30
minutes of operation (EVF usage)
when fully charged.
Remove the _Battery.
Slide the Battery out and then lift up.
About the Flashing of the CHARGE Lamp
• Charge the Battery within an ambient temperature range of 10 _C and 30 °C.
• If charging is done in extreme low or high temperatures, Battery charge time increases.
CHARGE Lamp flashes when...
: The Battery is being charged, but charging is taking longer than normal.
Charging is not possible. Remove the Battery once, wait a short time, then re-attach it
for charging.
Tilt Viewflnder u:
>ward.
Insert the Battery Pack and slide it
down until it locks with a click.
RELEASE Switch
To remove the Battery Pack:
Slide the Battery upward while sliding the
BATTERY RELEASE Switch.
To Next Page
Loading...
