Caution:
Charge only with specified charger.
Charge the Battery within an ambient
temperature range of 32° F (0° C) and
104 ° F (40 ° C).
• The Battery may be warm after charging
or just after use. This is normal.
• Do not use an insufficiently charged or
worn out Battery.
• If charging is done in extreme low or high
temperatures, Battery charge time
increases.
Safety precautions:
• Do not get the Battery near, or dispose of
in fire.
• Do not directly connect (shod circuit) the
positive (+) and negative (-) terminals.
• Never attempt to disassemble or
reassemble the Battery.
LI_-.,.]r-Tefl'._T;p.],_(,]
BATTERY RELEASE
Switch
To avoid damage to the Battery:
• Do not drop or jar the Battery.
• Use the Battery with specified models
only.
* If the Battery is used in extremely high
temperatures, a safety device will
automatically prevent operation.
To insure longer battery life:
° While not in use, remove Battery from
the Palmcorder and AC Adaptor and
store in a cool, dark, dry place. If you
leave the Battery in the Palmcorder or on
the AC Adaptor, the Battery wi_|no longer
be rechargeable.
, Keep the Battery terminals clean.
1
2
4
Slide the Battery upward while sliding
the BATTERY RELEASE Switch to
remove the Battery Pack,
(See page 11o)
lnsed the DC Cable into the DC IN
Terminal.
Connect the other end of the DC
Cable to the AC Adaptor as shown.
Plug in the AC Adaptor.
• The POWER Lamp on the AC
Adaptor lights up.
DC IN Terminal
DC Cable --
(Supplied)
12
• When not in use, unplug the AC Adaptor
from the AC outtet. (AC Adaptor
consumes 1W of electric power when
plugged into an AC outlet even when not
DC IN Terminal in use.)
POWER
_-DC Output Connector
To Next Page
Loading...
