EasyManua.ls Logo

Panasonic Digital Palmcorder PV-DV101 - Indications; Warning Displays and Conditions

Panasonic Digital Palmcorder PV-DV101
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
The following warning displays appear in the EVF and the LCD monitor.
-,[_.
TAPE NOT
INSERTED
CHECK
RECTAB
CANNOT REC
-[_ E,D-
I:A e'E.O
INCOMPATIBLE
TAPE
NEED HEAD
CLEANING
REMOTE
CANNOT REC
LP-MODE
-- WARNING -
DEW DETECTED
-- WARNING -
/11,%
LOW eATERY
CLOCK BATTERY
INCOMPATIBLE
DATA
If the Palmcorder is in CAMERA mode without a cassette inserted
_1._' will flash and "TAPE NOT INSERTED" will appear for 5
seconds. Recording will nol start.
If the Palmcorder is in CAMERA mode with the cassette sliding
record tab opened, "_L_j_ will flash and "CHECK REC TAB" will
appear for 5 seconds. Recording will not start.
When Audio dub is performed and the sliding record tab is open,
or a bIank portion of tape is detected, '_k" will flash and
"CANNOT REC" will appear for 5 seconds,
When the tape is about to end in REC mode, '@ END" will
flash and "TAPE END" witl appear for 5 seconds,
When an incompatible tape is detected, "INCOMPATIBLE
TAPE" will appear for 5 seconds.
If the video heads require cleaning, "NEED HEAD CLEANING"
will appear for 5 seconds.
When the Palmcorder and remote are not set to the same mode
(VCRt or VCR2), "CHECK REMOTE MODE" appears for 5
seconds. Also appears when the Palmcorder is first turned on.
When an AUDIO DUB is attempted on a pre-recorded LP tape,
"CANNOT REC LP-MODE" will appear for 5 seconds.
If excessive moisture condenses in the unit, "WARNING" will
flash, "DEW DETECTED" will appear, and the Pal_n'corder will
automatically turn OFF in 15 seconds.
In this case, wait until the indicator no longer flashes when your
Palmcorder is turned ON again.
When a battery recharge is necessary, "WARNING" will
flash, "LOW BATTERY" will appear, and the Palmcorder will
automatically turn OFF in 15 seconds. (See page 19.)
When the built-in lithium clock battery is discharged, "CLOCK
BATTERY" will appear. To re-charge the lithium clock battery,
connect the AC Adaptor to the Palmcorder. Recharging takes
approx. 4 hours. Reset the clock after charging.
If you play a tape recorded in a format other than NTSC or you try
to copy a copy-protected data, "INCOMPATIBLE DATA" will
appear.
21

Related product manuals