• Remove the lens cap and clip it to the hook.
t
Clip here POWER ZOOM Switch
Adjustment Switch
Centre1 _
POWER
Lamp
3RI_C/PAUSE
Button
WARNING:
• Do not leave the Palmcorder with the
EVF aimed directly at the sun as this
may cause damage to the internal parts
of the EVF,
Before you begin
Connect the Palmcorder to a power
source. (See pages 11, 12,)
• Insert a cassette with record lab closed.
(See page 6.)
1
2
3
Set POWER to CAMERA.
• The POWER Lamp lights red.
• Be sure POWER is fully turned to
CAMERA position. EVF
REC/PAUSE mode
With the Viewfinder Eye Cup up to
your eye, adjust the Vision
Adjustment Control to your eyesight.
(See page 10,)
Press REC/PAUSE to start recording.
• "REC" is displayed on the screen.
Press REClPAUSE again to pause
recording.
• To reduce microphone wind noise,
set the WIND-CUT to ON. (See
WIND-CUT on page 15.)
* Do not lift or carry the Palmcorder by the • When the Palmcorder is aimed at
EMF or the LCD Monitor. excessively bright objects, or bright lights,
_(_ a vertical bar may appear in the picture,
_. This is a normal characteristic of the CCD
pick-up device. Try to avoid this whenever
\\ possible.
To conserve power
Iter 5 minutes, the Record/Pause mode
ill automatically change to Standby mode.
o resume recording, set POWER to OFF
nd then ON again.
You can gradually zoom in tor close ups or zoom out for wide angle shots.
Zoom slowly : by Iightly pressing the "T" (Telephoto) or the "W" (Wide Angle) side of the
POWER ZOOM Switch.
Zoom quickly : by app_yirtg more pressure.
• The zooming speed ranges from a slow 22 seconds to a fast 2 seconds according
to the amount of pressure applied to the POWER ZOOM Switch.
22
To Next Page
Loading...
