The LCD (Liquid Crystal Display) monitor
can be used while recording.
1LCD-OPEN
Button
To adjust the LCD BRIGHTNESS I
or LCD COLOR
[
A Press MENU to display the main menu
screen.
B Rotate JOG KEY to select I!_
[L'_r_r_lfrom the main menu screen.
(See pages 16, 18.)
C Press JOG KEY to display the LCD/
EVF SETTING screen.
O Press JOG KEY to select
LCD BRIGHTNESS or LCD COLOR,
then rotate JOG KEY to adjust.
EPress MENU twice to exit this mode.
-Before you begin
• Connect the Palmcorder 1oa power
source. (See pages 11, 12.)
• Insert a cassette with record tab closed.
(See page 6.)
1
2
3
Press LCD-OPEN to unlock the LCD
monitor.
Swing the LCD monitor fully open
and adjust the viewing angle.
° The LCD monitor will automatically
turn on.
• When the LCD monitor is completely
dosed, it will shut off automatically to
save power.
• Adjust LCD Brightness and/or color of
the LCD monitor if necessary.
• Please refer to "To adjust the LCD
BRIGHTNESS or COLOR".
I 1
LC_ BRIGHTNESS
LGW _I[1 .... HIGH
L_ _OLON
LOW I I _I HIGH
LOW 1{{I _-- HIGH
-$_LECT: PUSH JOG KEY
-SET :FIOTATE _OG KEY
,_,£XlT :PUSH MI_NU KE'q
Start recording. (See page 22.)
• Using the LCD monitor will reduce battery
operating time.
• Close the LCD monitor completely when
not in use.
!-'t'_li i -',=(.(.]w,!m,[:mml
Rotate the LCD monitor 180 degrees so it
faces the same direction as the lens to
record yourself (CAMERA mode).
The picture in the LCD monitor will appear
reversed.
Set_to MIRROR (see page 15)
in the Camera mode menu screen to see
the picture as it is actually being recorded,
To Next Page
Loading...
