25
VQT1W46
Preparation
• When [PC] is selected, the camera is connected via the “USB Mass Storage” communication
system.
• When [PictBridge(PTP)] is selected, the camera is connected via the “PTP (Picture Transfer
Protocol)” communication system.
• This will work when the AV cable is connected.
• This will work when the AV cable is connected.
• Use a battery with sufficient battery power or the AC adaptor (DMW-AC5G; optional) and DC
coupler (DMW-DCC4; optional) when formatting. Do not turn the camera off during formatting.
• If a card has been inserted, only the card is formatted. To format the built-in memory, remove
the card.
• If the card has been formatted on a PC or other equipment, format it on the camera again.
• It may take longer to format the built-in memory than the card.
• If you cannot format, contact the dealer or your nearest Service Centre.
x [USB MODE]
Select the USB communication system after or before connecting
the camera to your PC or your printer with the USB connection
cable (supplied).
y [SELECT ON CONNECTION]:
Select either [PC] or [PictBridge(PTP)] if you connected the
camera to a PC or a printer supporting PictBridge.
{ [PictBridge(PTP)]:
Set after or before connecting to a printer supporting PictBridge.
z [PC]:
Set after or before connecting to a PC.
| [VIDEO OUT]
Set to match the colour television system in each country.
(Playback mode only)
[NTSC]: Video output is set to NTSC system.
[PAL]: Video output is set to PAL system.
[TV ASPECT]
Set to match the type of TV.
(Playback mode only)
[W]: When connecting to a 16:9 screen TV.
[X]: When connecting to a 4:3 screen TV.
[VERSION DISP.]
It is possible to check which version of
firmware is on the camera.
[FORMAT]
The built-in memory or card is formatted. Formatting irretrievably
deletes all the data so check the data carefully before formatting.
DMC-FS15GN-VQT1W46_eng.book 25 ページ ２００８年１２月９日 火曜日 午後７時４６分
To Next Page
Loading...
