Recording
28
DVQX1043 (ENG)
Recording 4K Photos
Applicable modes:
The camera allows you to take burst pictures of 8 million pixels (approx.) at 30 frames/
second. After taking these pictures, you can save the desired moment extracted from their
burst file.
• Use a UHS Speed Class 3 card to record 4K photos. (P11)
• When recording 4K photos, the angle of view is narrower.
1
Set the drive mode dial to [ ].
2
Select the menu. (P22)
¢ Motion picture file will be recorded and played back in separate files in the following cases
(You can continue recording without interruption.):
– When using an SDHC memory card: If the file exceeds 4 GB
– When using an SDXC memory card: If the continuous recording time exceeds 3 hours and
4 minutes or If the file exceeds 96 GB
> [Rec] > [4K PHOTO] >
[Rec Method]
[]
[4K Burst]
¢
For capturing the best shot of a
fast-moving subject
Burst recording is performed while the
shutter button is pressed and held.
A Press and hold
B Recording is performed
[]
[4K Burst(S/S)]
¢
“S/S” is an
abbreviation of
“Start/Stop”.
For capturing unpredictable photo
opportunities
Burst recording starts when the shutter
button is pressed and stops when pressed
again.
C Start (First)
D Stop (Second)
E Recording is performed
[]
[4K Pre-Burst]
For recording as needed whenever a
photo opportunity arises
Burst recording is performed for
approximately 1 second before and after
the moment that the shutter button is
pressed.
F Approximately 1 second
G Recording is performed
MENU
DMC-FZ2000MST-DVQX1043_eng.book 28 ページ ２０１６年９月１９日 月曜日 午前１１時１７分
To Next Page
Loading...
