Panasonic DMC-FZ70P - Page 17

17
Adj.History OIS 19*0 2000 OIS adj. Yaw direction amplitude error (small) OIS ADJ OIS ADJ
3000 OIS adj. Pitch direction amplitude error (small)
4000 OIS adj. Yaw direction amplitude error (large)
5000 OIS adj. Pitch direction amplitude error (large)
8000 OIS adj. Yaw direction off set error
9000 OIS adj. Pitch direction off set error
A000 OIS adj. Yaw direction gain error
B000 OIS adj. Pitch direction gain error
C000 OIS adj. Yaw direction position sensor error
D000 OIS adj. Pitch direction position sensor error
E000 OIS adj. other error
HARD FLASH Flash 28*0 0000 Flash charging error STRB CHG FLASH P.C.B./
FPC
IC6001-(AA23) signal line or Flash charging circuit
FLASH
ROM
(EEPROM
Area)
FLASH
ROM
(EEPROM
Area)
2B*0 0001 EEPROM read error FROM RE FROM
IC6002 (Flash ROM)
0002 EEPROM write error FROM WR FROM
IC6002 (Flash ROM)
0005 Firmware version up error (No indication) (No indication)
Replace the firmware file in the Memory Card
SYSTEM RTC 2C*0 0001 SYSTEM IC initialize failure error SYS INIT MAIN P.C.B.
Communication between IC6001 (VENUS ENGINE) and
IC9101 (SYSTEM)
SOFT CPU Reset 30*0 0001
|
0007
NMI reset
Non Mask-able Interrupt
(30000001-30000007 are caused by factors)
NMI RST MAIN P.C.B.
CPU,
ASIC hard
Stop 38*0 0001 Camera task finish process time out LENS COM LENSu/DSP
Communication between Lens system and IC6001
(VENUS ENGINE)
0002 Camera task invalid code error DSP DSP
IC6001 (VENUS ENGINE)
0100 File time out error in recording motion image
IC6001 (VENUS ENGINE)
0200 File data cue send error in recording motion image
IC6001 (VENUS ENGINE)
0300 Single or burst recording brake time out
Memory
area
3A*0 0008 work area partitioning failure (No indication) (No indication)
USB dynamic memory securing failure when connecting
Operation Power on 3B*0 0000 Flash ROM processing early period of camera during
movement
INIT (No indication)
Zoom Zoom 3C*0 0000 Imperfect zoom lens processing ZOOM ZOOMm/
LENSu
Zoom lens
35*0 0000
|
FFFF
Change to the dummy processing (=Illegal command)
(0-7bit : command, 8-15bit : status)
DSP DSP
35*1 0000 Though record preprocessing is necessary, it is not called
35*2 0000 Though record preprocessing is necessary, it is not
completed
(No indication) (No indication)
Attribute Main item Sub item Error code Contents (Upper) Error Indication
High
4bits
Low
4bits
Check point (Lower) Detecting
device
Part/Circuit