Reference
31
SQT0126
IP address is not set.
¾ The “IP Address” in “IP Address / DNS
Settings” is “---. ---. ---. ---”. Set the “IP
Address”, “Subnet Mask”, and “Gateway
Address”. (Select the automatic address
acquisition if necessary.)
The wireless access point currently has a low
network security setting. It is recommended to
change to a higher setting.
¾ Set a stronger network security level referring
to the wireless router operating instructions.
When the POWER LED is flashing, check the
message on the TV screen. If a message is not
displayed on the TV screen, determine the type of
the error by checking the way the POWER LED is
flashing.
Flashes 6 times
¾ The remote control and this unit are using
different codes.
Turn on this unit by using the standby/on
switch on this unit, and check “Remote control
” which is displayed on the screen when you
press a button on the remote control.
Press and hold [OK] and the displayed
number (“”) for at least 5 seconds.
Flashes
¾ The copyright protected disc cannot be
played back.
One of the devices connected to this unit (TV,
amplifier, etc.) does not support copyright
protection.
Flashes 3 times
¾ The disc in use cannot be played back since
the copyright information is invalid.
Specifications
≥ Specifications are subject to change without notice.
POWER LED
General
Signal system PAL/NTSC
Operating
temperature range
i5 oC to i35 oC
Operating humidity
range
10 % to 80 % RH (no condensation)
HDMI AV output Output connector: Type A (19 pin)
1 system
USB slot USB2.0:
[For[the[United[Kingdom[and[Ireland]
[For[Australia[and[New[Zealand]
1 system
[For]the]Middle]East]
[For[South[East[Asia] [For[ India]
2 system
Ethernet 10BASE-T/100BASE-TX 1 system
[BDT260] [BD91]
Wireless LAN
Standard Compliance:
IEEE802.11 b/g/n
Frequency range:
2.4 GHz band
Security: WPA
TM
/WPA2
TM
(Encryption Type: TKIP/AES,
Authentication Type: PSK), WEP
(64 bit/128 bit)
LASER Specification Class 1 LASER Product
Wave length: 785 nm (CDs)/
660 nm (DVDs)/405 nm (BDs)
Laser power: No hazardous
radiation is emitted with the safety
protection
Power supply
[For[the[United[Kingdom[and[Ireland]
[For[Australia[and[New[Zealand]
AC 220 V to 240 V, 50 Hz
[For]the]Middle]East]
[For[South[East[Asia] [For[ India]
AC 220 V to 240 V, 50 Hz/60 Hz
Power consumption Approx. 14 W
Power consumption
in standby mode
Approx. 0.5 W
Power consumption
in quick start
standby mode
Approx. 4 W
Dimensions
(WkHkD)
Approx. 312 mmk43 mmk180 mm
Mass Approx. 1.0 kg
DMP-BDT260&161&160&BD91&81_EBGNGCGAGW-SQT0126_eng.book 31 ページ ２０１４年２月２８日 金曜日 午前１０時４４分
To Next Page
Loading...
