Getting started
- 9 -
1 Disc tray (> 15)
2 USB port (> 15)
3 POWER LED
The LED lights up when the unit is turned on,
and flashes when error occurs. (> 33)
4 Remote control signal sensor
Distance: Within approx. 7 m
Angle: Approx. 20e up and down, 30e left and
right
5 Open or close the disc tray (> 15)
6
[BDT281/280] [BDT185/184/181/180]
Stop (> 17)
7
[BDT281/280] [BDT185/184/181/180]
Start play (> 17)
8 Standby/on switch (Í/I) (> 13)
Press to switch the unit from on to standby
mode or vice versa. In standby mode, the unit
is still consuming a small amount of power.
Rear panel terminals (> 10–12)
[BDT281/280]
[BDT185/184/181/180]
[BDT168/167]
[BD843/84]
To Next Page
Loading...
