Panasonic DMP-BDT210 - STEP 2: Connecting to an amplifier;receiver; Connecting via HDMI AV OUT; Connecting via OPTICAL Terminal

Connections & Settings
9
VQT3B58
STEP 2 : Connecting to an amplifier/receiver
∫ Via an HDMI AV OUT terminal
– It is possible to play back 3D videos and 3D still
pictures when the connected TV and amplifier/
receiver are 3D compatible.
∫ Via an OPTICAL terminal
≥ Set “HDMI Audio Output” to “On” ( 32).
≥ Set “Digital Audio Output” depending on the connected
amplifier/receiver ( 30).
≥ The HDMI connection supports VIERA Link “HDAVI
Control” ( 26).
≥ When connecting to a non-3D compatible amplifier/
receiver, connect this unit to a TV via HDMI AV OUT, then
connect the TV and the amplifier/receiver, using HDMI
cables for the respective connections.
– Please note, however, that the audio can only be up to
5.1ch.
≥ When using the TV or amplifier/receiver that does not
have the indication of “(ARC)” (non-ARC-compatible) on
the HDMI terminal, in order to enjoy TV’s sound by
amplifier it is also required to connect the amplifier/
receiver and TV using an optical digital cable.
≥ When connecting a TV ( 8) with HDMI AV OUT terminal,
set “HDMI Audio Output” to “Off” ( 32).
≥ Set “Digital Audio Output” depending on the used terminal
and connected amplifier/receiver ( 30).
HDMI IN
LAN
E-T/100BASE-TX
HDMI IN
HDMI IN
(ARC)
(ARC)
Multi channel
speakers
Amplifier/receiver
HDMI cable
HDMI cable
OPTICAL IN
Amplifier/receiver
Optical cable
DMP-BDT110_115_210_VQT3B58_eng.book 9 ページ ２０１０年１２月８日 水曜日 午後４時３９分