Reference
35
VQT3V20
U59
¾ The unit is hot.
The unit switches to standby for safety
reasons. Wait for about 30 minutes until the
message disappears.
Select a position with good ventilation when
installing the unit.
H or F
(“ ” stands for a number.)
¾ There is something unusual.
¾ Check the unit using the troubleshooting
guide. If the service number remains
displayed, do the following.
1 Disconnect the plug from the AC outlet, wait a
few seconds, then reconnect it.
2 Press [Í/I] to turn the power on.
If the service number remains displayed despite
doing the above, request service from the dealer.
Inform the dealer of the service number when
requesting service.
START
¾ The system is being restarted during the
firmware update. Please do not turn off the
unit.
UPD/
(“ ” stands for a number.)
¾ The firmware is being updated.
Please do not turn off the unit.
FINISH
¾ The firmware update is complete.
DMP-BDT220_VQT3V20_eng.book 35 ページ ２０１１年１２月５日 月曜日 午後５時３５分
To Next Page
Loading...
