Panasonic DMP-UB704 - Page 9

Getting started
- 9 -
∫ Front
1 Disc tray
2 Display
3SD card slot
When removing the SD card, press the centre
of the card and pull it straight out.
4 USB port ( DC 5 V 500 mA)
5 Remote control signal sensor
Distance: Within approx. 7 m
Angle: Approx. 20e up and down, 30e left and
right
6 Open or close the disc tray*
7 Standby/on switch* (Í/I) (> 17)
Touch to switch the unit from on to standby
mode or vice versa. In standby mode, the unit
is still consuming a small amount of power.
* These buttons work just by touching the marks.
Do not place any objects on or around the buttons.
∫ Rear
1 AC IN ( ) terminal (> 10)
2 LAN port (> 16)
3 HDMI AUDIO OUT terminal (> 11)
4 HDMI VIDEO OUT terminal (> 10)
5 DIGITAL AUDIO OUT terminal
(OPTICAL terminal) (> 12)
6 Cooling fan
7 HDMI OUT terminal
1
6
2 3 4 5
7
Pull to flip down
the front panel.
CAUTION
Do not place objects in front of the unit. The disc tray may collide with objects when it is opened, and
this may cause malfunction.

≥ When inserting a media item, ensure that it is facing the correct way, which is the right side facing up.
≥ If you connect a Panasonic product with a USB connection cable, the setup screen may be displayed on the connected
equipment. For details, refer to the instructions for the connected equipment.
21 53 4
7
6
Class II equipment (The construction of the product is
double-insulated.)
DMP-UB704_EG-TQBS0021_eng.book 9 ページ ２０１６年８月３０日 火曜日 午前１１時８分