1. Remove ATAPI Connector and HDD Power Connector.
2. Remove 4 Screws (A) to remove HDD Angle with HDD.
3. Put HDD with Angle up side down not to give a shock to
HDD.
4. Remove 2 screws to remove HDD.
Handling of HDD
The following precautions should be taken when
handling HDD.
a. Never give an impact to HDD. (Even a drop from 1
cm height can be a cause of HDD failure).
b. When placing HDD on a workbench, provide a mat
on a bench for shock absorption and anti-static
purposes.
c. When installing HDD, release it from your hands
only after confirming that it is fully set on the chassis.
d. Avoid stacking up HDD.
e. HDD is unstable and easy to fall. Do not stand it on
its side face.
f. When handling HDD, hold its side faces to avoid
static hazard.
g. Do not place HDD on its wrapping bag after removal.
(Prevention of static hazard.)
h. Use a screwdriver with low impact and anti-static
features.
Note:
When replacing HDD, please make the rear
jumper slave or cable select configuration.
33
DMR-EX75EG / DMR-EX75EC / DMR-EX75EB / DMR-EX85EG / DMR-EX85EB
To Next Page
Loading...
