Getting started
SQT0993
15
5 Set the Owner ID-Data Entry (“NAME”,
“HOUSE NO” and “POSTCODE”).
e.g.,
1 Select the item, then press [OK].
2 Select the character, then press [OK].
Repeat this step.
3 Press [BACK/RETURN ].
4 Repeat steps 1-3 to enter all data.
5 Press [BACK/RETURN ] to exit from
the Owner ID-Data Entry screen.
6 Enter the new PIN for parental control.
• The default PIN is “0000”.
1 Enter the new 4-digit PIN with the number
buttons.
• Make a note of the PIN you have
decided on in case you forget it.
2 Press [OK].
7 Set “Quick Start” to “On”, “Off” or “Timer
Setting for Quick Start”, then press [OK].
For details, refer to “Quick Start”. (> 64)
When “Easy Setting has been completed.”
appears, Easy Setting is complete.
- Select “Yes” to set network settings.
- Select “No” to finish the Easy Setting.
To stop partway
Press [BACK/RETURN ].
To restart setup (> 57, Auto Setup)
To display the Owner ID information on TV
1 While the unit is on, press and hold [OK], the
yellow button and the blue button on the
remote control at the same time for more than
5 seconds.
- The "INFO1" indicator on the unit will flash.
2Press [1] repeatedly until the "REC" indicator
on this unit lights up.
3 Press [OK] on the remote control.
The PIN is not displayed.
To change PIN for parental control
Refer to “PIN Entry”. (> 65)
To change the region for Channel Sorting
Refer to “Channel Sorting by Region”. (> 58)
• If tuning is cancelled partway through, it may not be
possible to receive the channels. Restart setup again.
Owner ID-Data Entry
NAME
HOUSE NO
POSTCODE
PIN 0000
RETURN
Change PIN
Select
0
Number
9
-
PIN Entry
Enter a new 4-digit PIN, then press OK.
This PIN will be used for controlling viewing and playback.
PIN will be set to “0000” by pressing “RETURN” when there is no
number input.
- - -
RETURN
DMR-HWT250_150EB_eng.book 15 ページ ２０１５年９月１４日 月曜日 午後１時５０分
To Next Page
Loading...
