70
2. Install the 1 Door Spring as shown in the figure.
9.1.5.3. How to apply Hanarl to the Door
Unit and Front Unit
• Hanarl application locations for the Door Unit and Front Unit.
• Hanarl is not applied to replacement parts.
• Apply adequate of the Hanarl to the designed locations.
(RFKXGUD24)
• Apply the Hanarl thinly using a toothpick.
9.1.6. BD Drive
1. Remove 4 Screws (A) and disconnect the Drive FFC to
remove BD Drive.
CAUTION:
When inserting the FFC, pay attention as below.
To Next Page
Loading...
