76
5. Push and remove the 2 Rubbers in the direction of
arrows.
6. Open the connector lock, and disconnect the FFC.
7. Slide the Slide Cam to the right until it can be.
8. Remove the Traverse Base Ass'y with pulling the 2 hooks
to the direction of arrows.
9. Remove the Slide Cam.
9.2.5. Drive Gear and Loading Motor
1. Perform the step "9.2.4. Traverse Base Ass’y and Slide
Cam".
2. Remove the Drive Gear.
3. Remove the 2 soldering points and 2 Hooks, and remove
the Loading Motor.
To Next Page
Loading...
