What to do if [ISO] and [F] are flashing on my Panasonic DMW-FL500?
If [ISO] and [F] are flashing, or the numbers for the ISO sensitivity and aperture are flashing, it means that the ISO sensitivity and aperture of the digital camera are outside the flash working range. To fix this, change the ISO sensitivity and aperture of the digital camera.
What to do if I can’t install my Panasonic Flashlight on my digital camera?
If you can’t install the unit on your digital camera, it might be because the lock pin is protruding. Turn the lock ring in the opposite direction from [2LOCK] until it stops and retract the pin before proceeding to install the unit on the digital camera.
Why won't my Panasonic DMW-FL500 power off?
When the power of a digital camera with communication functions is switched off, the flash is set to the power-saving mode. When the flash is used in combination with a digital camera without communication functions, it is automatically set to the power-saving mode when no operations have been performed for about 60 minutes.
General| Type | External Flash |
|---|---|
| Recycling Time | Approx. 3 seconds |
| Power Source | 4x AA batteries |
| Guide Number | 50 (ISO 100, in meters) |
| Compatibility | Compatible with Panasonic Lumix cameras |
| Tilt Angle | -7° to 90° |
To Next Page
