Panasonic EH-SA97 - Preparation; 1 Remove the Water Supply Tank from the Main Unit.; 2 Fill the Water Supply Tank with Water.; 3 Attach the Water Supply Tank to the Main Unit.

12
English
Preparation
1
1
Remove the water supply
tank from the main unit.
Pull it up at a slight angle.
2
2
Fill the water supply tank
with water.
1. Turn and open the water supply
cap.
2.
Pour water into the water supply
tank according to the course used.
FULL: [COURSE1], [COURSE2], [COURSE3],
[COURSE4], [WARM]
QUICK: [QUICK]
CLEANSING: [CLEANSING]
3. Close the water supply cap.
4.
Wipe away any water on the surface of the water supply tank.
3
3
Attach the water supply tank
to the main unit.
Push the water supply tank into the
main unit until it clicks.
• Water is supplied to the main unit
and the water in the tank
decreases when the water supply
tank is attached the main unit.
• If the water supply tank is not attached, the CHECK lamp
will blink and the steamer cannot be used.
• If the water supply tank is repeatedly attached and
removed, water may begin to leak from the water outlet.
4
4
Place the main unit on a flat,
level surface.
1. Spread out a waterproof sheet on
a flat and hard surface such as a
desk etc.
2. Place the main unit so that it
overlaps a little with the
waterproof sheet.
5
5
Insert the appliance plug into the main unit.
6
6
Plug in the power plug into the power outlet.
EH-SA97_HK.indb 12 2016/04/06 13:33:37