EN12
3) Pay attention to the distance
between the backrest and the
wall when placing the unit
Please check whether the backrest will hit
the wall
❶
Initial use
❷
Moving
Castors can be used when moving the unit.
Mats etc. Castor
Lift the unit to a position no higher than the
position of waist
①
After procedures
❶
,
❹
and
❺
of EN13, the indicator light
will ash, which means the
unit enters the standby mode.
The backrest of the massage
lounger is automatically lifted
from the delivered state to the
upright state.
②
When pressing
, the
indicator light is always on,
which means it is at the boot
mode, and at the same time,
the backrest of the massage
lounger tilts to the set angle (not
the lowest position).
③
When pressing
, the
indicator light ashes, that is,
it returns to standby mode,
and the backrest of massage
lounger will also return to
upright state.
④
Turn the power switch on the
back of the unit to "O" and
unplug the power plug.
When the backrest is fully raised.
Over 30cm
Over 5cm
When the backrest is
fully lowered
Don't
hold here
Settings (continued)
To Next Page
Loading...
