EP-MA10
ORDER NO. HPD1008U17CE
- 37 -
4.10.7. Adjustment of Massage mechanism block up/down sensor gear
You need to adjust the Up/down sensor gear after re-installing the Massage mechanism block to the Rear frame,
because the position of the Up/down sensor gear is changed.
Procedures of adjustment of Up/down sensor gear
1. Before re-installing the Massage mechanism block, set the Controller at the manual mode and move it to the
highest position
by pushing the button . (Refer to the Procedures of Manual mode to set at the manual mode.)
Caution : If the overrun happens, the Up/down worm wheel may crack.
※ One ‘click’’ of the gear means that the stroke changes for 4mm.
There are two lines on the right Rear frame. Adjust the height of the Up/down sensor PCB between the
lines as the figure.
2. Adjust the Up/down stroke by the Up/down buttons on the Controller.
To Next Page
Loading...
