1
Make sure the covering is free of rips or tears.
2
Make sure there are no obstacles between
the parts of the unit.
3
Make sure the massage heads are in the
retracted position, i.e. they are parked to the
left and right in the upper part of the backrest.
If not retracted, press twice to return the massage heads to the
retracted position.
4
Make sure the legrest is lowered.
Do not sit on the legrest when it is raised. Doing so may cause it to
collapse down or bend the legrest. The legrest is not meant to
support full body weight.
See Warning No. 8 on page E3 and No. 7 and 13 on page E4.
•
6. Flipping up the pillow
When you flip up the pillow, you can firmly massage your neck
and shoulders.
7. Adjusting the reclining angle
1
Press the button on the control panel to turn on the power.
2
Press and to adjust the angle of the backrest and legrest.
With either button held down, movement will continue until a “beep-beep-beep” sound indicates the legrest or backrest has
been raised or lowered as far as possible.
The legrest will start to move shortly after the backrest.
Approx. 85˚
Approx. 0˚
Approx. 115˚
Approx. 160˚
* The reclining operation is a function that adjusts the angle of the backrest and legrest. Avoid using it for any other purposes,
such as continuous up/down operation etc.
If the power switch is set to “off” or the power plug is disconnected
from the electrical outlet with the massage heads not in the retracted
position, the massage heads may automatically return to the
retracted position when
is pressed next time you use the unit.
A display shown to the right may appear, but this is not a malfunction.
You will be able to use the unit normally after the massage heads
stop moving.
•
•
To Next Page
Loading...
