GB11
English
Setting up the massage lounger
1 Where to use the unit
• Ensure adequate space to recline.
• Do not expose the massage lounger to direct sunlight or high
temperatures, such as in front of heating sources, because this can cause
discolouration or hardening of the synthetic leather.
• Place the unit on a mat to prevent oor damage.
• When placing a mat under the unit, the size of the mat should be sucient
(at least 120 cm × 70 cm) to cover the areas where the unit touches and
where the legrest could touch the oor, as shown in the diagram on the
right.
• Install the unit near a power socket.
See Warning No. 10 and 12 on page GB1, and Operating Precautions No.
14 on page GB4.
Keep at least 10 cm away from the wall.
Approx. 202 cm
Width approx. 95 cm
Approx.
30 cm
Approx. 49 cm
Mat Area where legrest
could touch the oor
Area where unit touches
the oor
2 Installing the unit
Groove
Hold onto the
sides of the
legrest.
Mat
Legrest
Back cover
Place your
ngers in the
groove
Do not hold onto
the front side.
The sole massage
section might slide,
and injuries may
occur.
Hold onto the sides.
• Since the unit is very heavy (approximately
87 kg), be careful to avoid back injuries. (The
unit must be carried by two or more
persons.)
To put the unit down on the
oor
• Put the unit down slowly and carefully
watch your step.
• Put down the legrest by holding it with your
hands until it has been set on the oor
completely. If you release your hands before
the legrest is fully extended, the legrest will
forcefully return to the initial position.
• The oor may get damaged, so it is
recommended to place a mat etc. on the
oor.
See Warning No. 22 and 23 on page GB3.
EP-MA70_EN1.indd 11 2011/02/15 17:56:14