GB25
English
To start a saved programme
1
Press the button to turn on the power.
• The power is turned o automatically if 3 minutes or more pass
without operation.
2
Select the User button with your saved
settings.
• The selected User button will light. (Example: )
Press.
3
Select and press the Automatic programme
that was saved using the User button.
(Example: “REFRESH”)
The massage with your stored settings will
start after body scanning.
• If you select a dierent automatic programme than that which was
stored with your saved settings (using one of the user buttons), your
saved settings will not be reproduced. Only the saved settings
regarding the “Heat” massage heads and Voice guidance volume will
be applied. (See page GB24.)
2
3
1
To delete your saved settings (Example: )
1
Press the button to
turn on the power.
Select the programme
number you want to
delete.
Press.
2
Press again and hold for
more than 3 seconds
until the button changes
to ashing.
Press and hold for
more than 3 seconds.
3
Press again while the
button ashes (about
10 seconds).
Press.
Deleting is completed once the
ashing stops.
EP-MA70_EN2.indd 25 2011/02/15 17:57:15