Panasonic EP-MA73

EN18
Assembly
（Continued）
5
Turn on the power and raise the backrest to the upright position.
Insert the power plug into the
power outlet.
● Always be sure to insert into an AC
120 V plug.
Fasten the controller
cord using the clip.
● Fasten so the cable under
the clip will not sag too
much with the backrest
raised.
(Because there is a
chance of the cord
becoming tangled with
your feet, etc.)
Placing the controller
into the cont
roller
stand.
Confirm the lock switch key
is set to the open position.
Confirm the power switch is
set to the on position.
Press
on the controller twice.
● Press once, and then press again approx. 1 second later.
Backrest will rise automatically.
Insert the power plug into the
power outlet.
●
Always be sure to insert into an AC
●❶
Fasten the controller
cord using the clip.
●
Fasten so the cable under
●❷
Placing the controller
into the controller
stand.
●❶
●❶
●❷
●❷
●❶
●❸
Confirm the lock switch key
is set to the open position.
●❷
Confirm the power switch is
set to the on position.
●❸
Press
●
Press once, and then press again approx. 1 second later.
Backrest will rise automatically.
●❹
6
Placing the controller
When the controller stand is attached on the left side
EP-MA73_EN.indb 18 2014-4-24 10:24:06