EN30
How to Use
After the automatic course has finished,
or when the massage is completed by
pressing
during the course
Select and press one button from
that you would
like to register while the buttons
are flashing (approx. 15 seconds).
● Selected button will light. (Example: )
When the registration is completed
● Be careful since registered contents will not be
saved when the power switch is turned “Off” or the
power cord is disconnected during the massage.
●
Pressed button will turn off, and the power will be
turned off automatically in approximately 3 seconds.
You can register your preferred settings set during the automatic course, and have them reproduced next
time yo
u are massaging.
Your preferred settings (pages EN28–29, EN51
(volume)) are displayed and the USER buttons will flash.
◦❶
◦❷
If there is another setting already
registered, Other settings are already
registered. will be announced.*
■ To update to contents of new setting*
Press the same button again.
*
This will also be announced when you try
to register to a separate automatic course
or same automatic course contents that
are the same as those already registered.
■ If you do not want to delete the setting
already regis
tered
Press other USER button.
Press.
Press.
Automatic course
To register your preferences
・Air intensity and back intensity settings
・Air and stretch on/off settings
・
Heat massage heads on/off setting
・
Foot Heat on/off setting and temperature settings
・Voice guidance volume setting
You can register settings for each automatic course
in each USER button.
The last setting registered for the USER button is
applied regardless of which automatic course is
used.
For example, you can register th
e following different
settings in USER
To Next Page
Loading...
