To Next PageTo Next PageWhat to do if my Panasonic Massager unit will not operate at all?
The power cord might be disconnected, the power switch on the unit might not be turned on, or a Pre-Program button or Manual Operation button hasn’t been pressed after pressing the power button.
What to do if my Panasonic EP30007 - Real Pro ULTRATM backrest does not return to the upright position?
If the unit is stopped by automatic shut-off or by pressing the button, press the power button twice to return from the reclined position to the original position.
What to do if the massage heads stop during operation of my Panasonic EP30007 - Real Pro ULTRATM?
If excessive force is applied to the massage heads during operation, turn off the power switch, wait about 10 seconds, and then turn it on again. If the massage heads stop again, adjust your position so that your back is not completely in contact with the backrest.
How to fix massage heads that do not come up to the shoulder or neck in Panasonic EP30007 - Real Pro ULTRATM?
Sit in the deepest position on the seat and put your head on the pillow, then repeat the operations from the start if your head does not contact the pillow or your back does not contact the backrest.
What to do if my Panasonic EP30007 - Real Pro ULTRATM power cord or power plug is abnormally hot?
Stop using the unit immediately if the power cord or power plug is abnormally hot.
What to do if my Panasonic EP30007 - Real Pro ULTRATM has been damaged?
If the unit has been damaged, stop using it immediately.
What to do if it is not possible to recline my Panasonic EP30007 - Real Pro ULTRATM or the legrest cannot be raised or lowered?
If the unit encounters an obstacle or if excessive force is exerted on it during operation, turn off the power, wait approximately 10 seconds, and then turn it on again to operate the unit.
Why does my Panasonic EP30007 - Real Pro ULTRATM Massager make motor noises?
These sounds are perfectly normal and will not affect how the unit works.
Why reclining does not take place even though a massage is started in pre-programs of my Panasonic EP30007 - Real Pro ULTRATM Massager?
In some cases the seat may not automatically recline depending on the position (angle) of the backrest or the legrest.
Why is the height of the left and right massage heads different on my Panasonic EP30007 - Real Pro ULTRATM Massager?
The unit employs an alternating tapping method, so there is nothing wrong with it.
General| Massage Techniques | Kneading, Tapping, Shiatsu, Rolling |
|---|---|
| Heat Therapy | Yes |
| Foot Massage | Yes |
| Body Scan Technology | Yes |
| Adjustable Recline | Yes |
| Bluetooth Connectivity | No |
| Type | Full-Body Massage Chair |
| Timer | Yes |
Instructions on selecting an appropriate location and ensuring adequate space for operation.
Steps for unpacking the unit and preparing it for use, including lifting and placement.
Verifying that all main unit components and accessories are present in the box.
Instructions for attaching the armrests to the main unit using screws.
Procedure for connecting the air plugs to the unit, ensuring they click into place.
Guide for attaching the control panel stand to the armrest, specifying screw tightening.
Steps to attach the covers for the control panel stand on both sides of the unit.
Procedure to return the backrest to its upright position using the control panel buttons.
Instructions for repositioning the control panel cord to the left side of the unit.
Steps to fit the control panel into its designated holder on the control panel stand.
Guide for inserting the shoulder plate into the outer shoulder massage unit.
Instructions for attaching the pillow to the unit using velcro fasteners.
Focuses on shiatsu massage to loosen deep-seated knots, recommended for severe stiffness.
Uses kneading to manipulate and loosen muscles, recommended for mild stiffness.
Uses Swedish massage to invigorate and promote circulation, recommended for fatigue.
Uses compression to stretch muscles and joints, recommended for a refreshing stretch.
Covers all areas with various massage actions in a short 5-minute span.
Body scanning commences upon program selection, detecting height ranges.
Massage heads lower and perform tapping to determine shoulder height.
Massage begins after scanning; legrest adjusts automatically based on body scanning results.
Instructions on adjusting legrest and preparing for hand/arm massage before starting.
Details on changing intensity, legrest, stretch, and other settings during an active massage.
Instructions to turn on the unit and open the cover to access the Self-Program function.
Procedure to set time and intensity levels for neck, shoulder, back, and lower back.
Pressing the OK button to initiate the self-programmed massage after setup.
Instructions to turn on the unit and open the cover to access the Manual Operation function.
Choosing the body part to be massaged, including full back option.
Choosing the specific massage action or style for the selected body part.
Pressing the OK button to begin the manual massage after selection.
Detailed explanations and illustrations of various massage actions like Ultra Knead, Shiatsu, Knead, etc.
Details on variations like TAP 1, TAP 2, REGIONAL ROLL, and AUTO WIDTH.
Using the Ultra Knead and Repeat functions to enhance massage effectiveness.
How to select and change the massage style during operation.
Procedure for adjusting the massage speed in manual operation mode.
Methods to adjust the massage intensity in different modes and steps.
Fine-tuning the position of the massage heads during operation.
Detailed explanations of Thumb-like, Palm-like, and Fist-like massage actions.
Information on intensity range adjustments and limits for upper body massage.
Steps to turn air massage on/off for different body parts and check display status.
Procedure to adjust the intensity level of the air massage in 5 steps.
Guidance on adjusting legrest length for smaller and taller individuals.
Information on the removable foot reflexology plates and how to insert them.
Instructions for adjusting the reclining angle of the backrest and the angle of the legrest.
Steps for extending the legrest to a preferred position using the slide lever.
Instructions on how to position and insert hands for the hand/arm massage feature.
Troubleshooting and adjustments for obtaining a good outer shoulder massage.
Guidance on adjusting the seat/thigh soft massage plate for optimal positioning.
Instructions to turn leg and arm stretch functions on or off using control buttons.
Detailed steps for performing the leg stretch massage with the legrest.
Detailed steps for performing the arm stretch massage using backrest movement.
Procedure to adjust the volume level of the voice guidance prompts.
Guide for adjusting the direction of the pivoting control panel stand.
Steps to adjust pillow height for correct massage positioning during use.
Instructions for saving customized massage settings to user memory slots.
Procedure to recall and use previously saved massage settings.
Steps to erase saved user program settings from the unit's memory.
Procedure to return the chair to its upright position after massage completion.
How to safely stop the massage and return the legrest and backrest.
Using the emergency stop button to immediately halt all operations.
Steps to turn off the power switch, lock the switch, and remove the plug.
Instructions for cleaning synthetic leather surfaces with a soft cloth and mild detergent.
Procedure for cleaning the seat fabric, including spot cleaning soiled areas.
Instructions for safely lifting and moving the massage unit, avoiding damage.
Procedure for carefully placing the unit on the floor after moving.
Steps for moving the unit using its integrated wheels, ensuring stability.
