6
English
How to use
1
2
Apply a small amount of toothpaste.
3
To avoid splashing of toothpaste, put the head in your
mouth before turning the power on.
4
experience a tickling or tingling sensation caused by the
sonic vibrations. The sensation should subside after you
use the brush several more times.
5
Turn off the main body before removing it from your mouth
to prevent saliva from splashing.
Note
• The use time after a full charge is as follows.
ER‑CBL1: 110 minutes
ER‑CBN1: 70 minutes
(Use time may vary depending on ambient temperature and
use conditions.)
Even though the battery runs out, you can use for 5 minutes
after 3‑minute charge.
(This will differ depending on usage.)
Removing and mounting
• Make sure that the main body is turned off.
a
Stand the head when it is removed.
Removing and mounting
the brush
Rotate the head and align the marks and pull to remove
1
Pulling the brush while it is fastened may damage the head or
the main body.
head, put it in water or warm water for a while and then remove.
Align the mark on the brush with the mark on the head and
2
Inserting the brush without aligning the mark on the brush
with the mark on the head may damage the brush or brush
shaft (b).
Note
•
The brush should be replaced with a new one every 3 months
or so due to hygiene reasons, even if its shape is unchanged.
Even within 3 months, please exchange the head if the
bristles are frayed.
To Next Page
